Assistance Please - What Am I Doing Wrong - Plane Selection

[DD_Friar]

Salute

 

I wonder if someone can put me straight as to what I am doing wrong with this scenario. 

When I run the mission as a co-op my plane selection screen looks like the attached picture (A20 Config3).

As opposed to what I am familiar with, for example when using the complex co-op sample generated mission ( Sys gen2)

Below is a comparison of how I have configured the mission and what the sample co-op configuration looks like.

 

I know I am being a numpty with something but I can not see what I am doing wrong, its probably in clear sight!

I have put the A20's in a group as well just the same as the sample

Your advice would be very much appreciated.

[JimTM]

Try removing the hyphen from the A20 names, for example "A20 1" rather than "A20-1".

Edited November 13, 2020 by JimTM

[Sketch]

Post your mission here and we can take a look at it. It's possible the dash in the "A20-1" is causing the issue. Damn, @JimTM beat me too it.

Edited November 13, 2020 by Sketch

[DD_Friar]

Resolved.

It was the dash. I have taken that out and the planes are now grouped next to a single picture

 

Many thanks guys, much appreciated.

 

Salute

Friar

[JimTM]

Sketch and I say "You're welcome!"