Repeating Proximity Triggers?

[TP_Fritz]

Is it possible to have Proximity Trigger MCUs repeat?

 

For example, looking at @JimTM's Mission Editor Manual, on page 87 there is the "Detect the Proximity of Objects to One Another" example.  Is it possible to create this in such a way so that the Proximity detection is constant, instead of a single trigger fire for both Inside and Outside?  So, for example, if a Fw190 enters the Proximity IN radius and then exits the Proximity OUT, they reset so once the convoy resumes it will once again panic if another 190 enters the Proximity IN radius, ad infinitum?

 

(image courtesy of JimTM's manual)

Edited June 2, 2020 by TP_Fritz

[Jaegermeister]

A Checkzone would do that

[JimTM]

1 hour ago, TP_Fritz said:

Is it possible to have Proximity Trigger MCUs repeat?

 

For example, looking at @JimTM's Mission Editor Manual, on page 87 there is the "Detect the Proximity of Objects to One Another" example.  Is it possible to create this in such a way so that the Proximity detection is constant, instead of a single trigger fire for both Inside and Outside?  So, for example, if a Fw190 enters the Proximity IN radius and then exits the Proximity OUT, they reset so once the convoy resumes it will once again panic if another 190 enters the Proximity IN radius, ad infinitum?

...

 

Yes. In the example you show, each time the FW190 comes within the "Detect Close" proximity, the convoy stops.

Edited June 2, 2020 by JimTM

[TP_Fritz]

12 hours ago, JimTM said:

 

Yes. In the example you show, each time the FW190 comes within the "Detect Close" proximity, the convoy stops.

 

Ahh, okay, I didn't realize the Proximity MCU would - essentially - stay perpetually active.  I kept trying to create a typical setup with Deactivate and Activate MCUs, and of course that wasn't working.

 

Thanks!