JoyToKey and CH pedals

[JG1_Wittmann]

I have joytokey CH Fighterstick, Ch pro throttle, and CH pedals.   WHen I bring up joytokey all 3 say connected but only 2 configured.  When I try to change the 2 joysticks to 3 it does bring up a 3rd joystick tab, but then crashes. The pedals work in game for flying,  but I would like to make them traverse the turret fast speed.

 

Anyone have any ideas  ?

[JGr2/J5_Baeumer]

I have similar setup with CH fighterstick and pedals.....I use Joy2Key to map my stick to the turret traverse....as others do....Thad posted a screen shot of the somewhat arcane settings one needs to discover that are helpful....although my setup uses slightly different values....you can experiment to find what works best for you....if I find the link to that post I'll try to post it here, if Thad hasn't already done so.

 

I use the pedals to control the tank directionally as that feels most intuitive to me.

 

Edit:. found the thread....pay attention to the values in the parentheses and the direction of the arrows in the picture on this thread 

 

 

Edited August 7, 2019 by J5_Baeumer

[JG1_Wittmann]

J5_Baeumer,  I appreciate the reply      

 

I was able to map a few things,  including mouse movements  to  throttle  tried stick, didn't like the feel.   The big problem I am having is  programming anything

the the ch pedals.   I'm  new to jtk   has anyone been able to program 3 joysticks,  instead of the default 2 ?    Or maybe know of something different I need to

do with the pedals to get them to work in jtk ?

 

 

[JGr2/J5_Baeumer]

Try different values in the jtk mapping.....to get the feel and more importantly the speed of turret turn you are comfortable with.....mine turns faster the more zoomed put I am a d turns slower when zoomed in.....

 

Re the joysticks....I think it may be possible to add controllers in jtk....look at the tabs....one for each controller....

....I have not done this however so am not entirely sure.....if you have two joysticks and a set of pedals....you may need to add all three and activate them as a group in the CH controller software.... unfortunately I have not had a lot of luck working with the CH software....