Pimax Crystal Light + 4080 Super Setup

[ITAF_Greycap161]

Good morning everyone
I have the Pimax Crystal Light + 4080 Super but I don't see the long distance spots that my friends with older VR and video cards see.
I don't know what to do anymore and it's very frustrating.
Can someone tell me what I need to load (Open VR,,,,,), NVIDIA setting, IL2 setting and Pimax Crystal Light setting, please?
Otherwise I'll throw it all away,,,,,,,,,
thanks
Greycap

[=MERCS=JenkemJunkie]

Higher resolutions will decrease spotting ability, so lowering your resolution to theirs should work if you're running the crystal at high resolutions. I know that kind of defeats the point of having a crystal, but unfortunately that's how spotting works. I don't know if having hardware with a larger pixel density vs your friends headsets will also impact spotting at equal resolutions set in the software though.

[spreckair]

This is interesting to see.  I switched from a HP Reverb G2 to the Crystal Light and my spotting has not changed.  I still cannot ID the spotted aircraft in VR that well, but I can spot bogeys just as well.

[dgiatr]

8 hours ago, spreckair said:

This is interesting to see.  I switched from a HP Reverb G2 to the Crystal Light and my spotting has not changed.  I still cannot ID the spotted aircraft in VR that well, but I can spot bogeys just as well.

If you use vr zoom button when you spot a plane then is it possible for you to identify it?

 

 

I changed from Hp G2 to Quest 3 and added a little more resolution ( from 2700 to 3000) with better idying and not worse spotting results...

Edited April 14 by dgiatr

[=MERCS=JenkemJunkie]

You should notice a decrease in spotting ability with larger increases in resolution. When I tried tweaking on my Q3 I could make planes invisible somewhere around 5-7km+ by setting the resolution too high. I didn't even think it was possible to get spotting that bad.

[dgiatr]

28 minutes ago, =MERCS=JenkemJunkie said:

You should notice a decrease in spotting ability with larger increases in resolution. When I tried tweaking on my Q3 I could make planes invisible somewhere around 5-7km+ by setting the resolution too high. I didn't even think it was possible to get spotting that bad.

i think that no more than 3000 in QUEST3 is the ideal level for spotting and idying ability at the same time..

Edited April 14 by dgiatr

[spreckair]

5 hours ago, dgiatr said:

If you use vr zoom button when you spot a plane then is it possible for you to identify it?

When I zoom, it is harder to see the spotted aircraft.  Counterintuitive, right?

[CAG_Sanders]

It all has to do with how games render far planes, normally just a pixel or few. Obviously if you have a super high resolution headset your pixels are tiny so less likely to see a small black single pixel. Also it is known that zooming doesn't help spotting.