Not all settings seem to match the regional setting chosen in the flight interface

[--[---MAILMAN----]

I have only flown the quick missions and scripted campaigns for USAAF & RAF aircraft.  My Regional settings  for Measurement units is set for Plane Dependent.   The way point distances and ranges to other aircraft as seen from the cockpit, however, are using metric measurements even though the map way point information and instrument panel at the lower left of the screen is using imperial measurements.  This is moot for online play because those settings are turned off on the servers I fly.

 

Is there a setting that can be edited for the way points and ranges as seen from inside of the cockpit to be rendered in imperial units?

 

Is there an edit to have the convergence settings rendered in imperial units (yards or Feet) instead of meters?

I am trying to set my convergence for example at 300 yards which is 274.32m, but because of the increments I have to select 270 or 280m.  Can the convergence slider be edited to make finer adjustments to more closely match the imperial measurement?

 

Thanks

[LukeFF]

8 hours ago, --[---MAILMAN---- said:

Is there an edit to have the convergence settings rendered in imperial units (yards or Feet) instead of meters?

I am trying to set my convergence for example at 300 yards which is 274.32m, but because of the increments I have to select 270 or 280m.  Can the convergence slider be edited to make finer adjustments to more closely match the imperial measurement?

 

Not right now, no.