Using OVGME/JSGME for different keybindings/hardware setups

[Weegie]

I very rarely post on the frums but browse quite often

 

I really like the game sim, as it offers great value and a wide range of airframes to get shot down fly.

 

When flying the single engined fighters I prefer to have my dual throttle configured for a throttle/RPM setup, but flying the dual engines have it set for left/right throttle and although not a huge deal it's a bit of a pain to keep reconfiguring.

 

What I've done is make a configuration files in OVGME for the single engine and another for the twin engines to the input folder and just swap as required.

 

This is probably obvious/old hat to many but it was a bit of Eureka moment for me. It could easily be extended further to have different setups for each aircraft.

 

It will require a game restart but that's no biggie.

[KPnutskgwanchos]

Yeah I use JSGME to switch between 2D and VR flying ...   was a bit of Eureka moment for me for me too ... great advice from this forum as always

[[CPT]Crunch]

Or you can look at the last posted game update and wait a bit.

[kendo]

Yeah, things are changing ?

 

[SYN_Vander]

1 hour ago, KPnutskgwanchos said:

Yeah I use JSGME to switch between 2D and VR flying ...   was a bit of Eureka moment for me for me too ... great advice from this forum as always

Same here!

[Weegie]

57 minutes ago, kendo said:

Yeah, things are changing ?

 

Gotcha I did see that update but misread the understanding thinking it was limited to stick curves etc:

 

If it's a complete profile for reconfiguring all the hardware that'll be great and negate the need to use OVGME/JSGME