Controller Axis Not Being Detected

[Spook109]

I have MFG Crosswind 2 pedals. These have three axis: rudder, left brake, right brake. Everything has always worked. I went to adjust the dead zone on the two brake axis' and noticed they needed calibrated. I used the MFG config software to update the pedal's firmware to the most recent version and then calibrated all of the axis'. 

 

Now, the two brake axis' are not being seen at all by IL-2. Although, the rudder axis is being seen and works fine.

 

I checked them again in the MFG tool, Windows USB Game Controllers settings, and DCS. They work as expected in each of these apps.

 

I haven't disconnected any USB controllers nor have I done anything with my rig that "confuse" IL-2.

 

Anyone have any ideas?

[VA_NAVY]

No Ideas yet But I have exact same issue.

[[CPT]Crunch]

If you update firmware sometimes the hardware identity changes too.   You might have to delete the old line in your device listing, data, input, devices file.  Or even delete the entire input folder and let it all rebuild anew, the surest way.