Missions Rhineland takeoff

[Angry_Kitten]

flew the P51D and P47 and the ME262 missions. 

  

 

Complete failures in each one. 

 

ALL 3 have an issue with the visibility circle hiding the runway. Couldnt find it. 

 

The terrain kept changing on me. I saw a nice flat field driving my p47, so i flew it as a runway.. Somehow there was a big drop in it, that wasnt on screen until i flew over it and flipped upside down when i hit the ground. 

 

For some reason the P51-D couldnt take off either. 

 

Flew the ME262 mission twice.    Both fails

 

1st time. 

           The engine data on the side notes did not match what i was doing.  I had to do the standard e button startup, then apply the two button me262 startup keyboard command listed in the engine controls panel in keyboard bindings list. 

  Despite using the 0 button command to operate both engines as one, i had to input the  two seperate engine start commands SEPERATELY for both engines.

 

Despite engines being fully on, and blasting exhaust the plane would not move. I tried using the turn brakes/wheel locks off, NO RESULT.   

 

I hit the left arrow key on the key board, the RUDDER turned to the left slightly and the plane started rolling.  

 

Even with full emergency power the me262 could not take off, and could not achieve a speed over 185km  even with the flaps set to 30 degrees it still could not get take off speed.

 

Second attempt really screwy things happened.  

 

I applied the standard E button startup.... NOTHING happened.  the two button keyboard code got engine 1 running.  When engine 1 was running, i had to apply the two button code to start engine two. Yes i waited about 4 minutes after engine one was fully running and engine 2 had not started up yet.   When engine 2 started the start up procedure, engine 1 TURNED OFF..    But when engine 2 was fully running, engine 1 started up without ANY inputs from me. 

 

Then i could not get the plane moving...  i tried using the keyboard arrows too change the rudder trim.  NOTHING HAPPENED on screen, i mean nothing happened. 

Then i applied the keyboard command to unlock brakes/wheel locks... NOTHING 

 

after 6 minutes of swearing the plane started moving in a left hand circle, despite BOTH engines being at 100%, applying full right rudder, and both wheels turning on screen. 

 

To be cute I used the F key and changed the flaps angle. Despite the onscreen technote telling me the flaps were at 30 degrees, NOTHING changed on screen. After 2 minutes of waiting, i applied the retract flaps command, and the technotes told me flaps fully retracted, no movement occured.