Halon Posted March 21, 2021 Posted March 21, 2021 (edited) Evening All, I'm still plugging away with my PE-2 and occasionally A20 and been doing a lot of level bombing and getting a lot better at getting in the general area of target. Anyway this question is about tree top level bombing which I'd not really tried much for a long time. Whilst reviewing a bombing run in my A20 I noticed that I was getting really good direct hits on buildings however none of these bombs blew up (I don't think any of my bombs missed - certainly nothing blew up). Its almost like they just smacked into the structures and broke up. I was using a one second time delay rather than my usual three for low level stuff and I was very low to the ground so wondered if I'd set it up wrong or needed to be a bit higher? Maybe Dimitri forgot to take the pins out? Edited March 21, 2021 by Halon
56RAF_Stickz Posted March 21, 2021 Posted March 21, 2021 you need to use 3 or 5 second delay for tree level bombing else they will not explode ( assuming you have also not unarmed them) 1
Ghost666 Posted March 21, 2021 Posted March 21, 2021 Any thing less then a 5 Sec. delay needs to be from higher up. Set them for 5 and they will go BOOOOOOOMMMM! ? 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now