Help binding rudder trim to paddles on TWCS Throttle

[Dead_Reckoning96]

I’m trying to bind rudder trim to the paddles designed to be used as the rudder on the Thrustmaster TWCS throttle. Right now when I release the paddle it returns my rudder trim to 0%. Is there a way to make it so it stays where I left it after I release it? Probably best to just set up each paddle as a button press but I’m having trouble figuring out how to do that

[jollyjack]

I had that unit briefly; i don't think that's possible ... only if you stick some Gaffer tape to the paddle.

[Sokol1]

33 minutes ago, Dead_Reckoning96 said:

I’m trying to bind rudder trim to the paddles designed to be used as the rudder on the Thrustmaster TWCS throttle. Right now when I release the paddle it returns my rudder trim to 0%. Is there a way to make it so it stays where I left it after I release it? Probably best to just set up each paddle as a button press but I’m having trouble figuring out how to do that

 

You can't use a axis with return to center spring for a command that that require a relative position position, e.g. rudder trim, because as you notice this axis in repouse always return to center.

 

However, if you are able to use TARGET software in C# programming, can try with the axis in relative mode.

So pressing right tab the axis value  start increase, and when you release the tab, the adjust remain in last position.

Pressing left tab the axis start decrease, from the last value adjusted.

Don't sounds too practical, but at least are an option.

 

Other is set this axis for press keys and use this keys for adjust trim is easy, though TARGET GUI or JoyToKey, Joystick Gremlin...