Gladiator-K calibration issue

[Niagara]

Any body have trouble getting it to self calibrate  ... any fix ?

I go through the procedures  all goes fine until i press the trig to end and reset the cal ,, and then both red and green light start to flashing , and never stop ..

mod button inop , wont cycle to red or green modes.

[Tarapatraptar]

If you're doing the cold calibration, without software, you have to calibrate ALL axes: pitch, roll and twist, ministick (if you have the Premium SCG) and the throttle. If any of these axes is not calibrated the lights will flash.

 

[Niagara]

Yup : did that as per video about 10 time == no joy !!!

[Tarapatraptar]

Is the small round red LED on SCG head on or off when you're calibrating?

[Niagara]

off== only the blue light on .. by the way  it is a standard ver= no thumb hat switch =just a button ..

Edited July 19, 2020 by Niagara

[Tarapatraptar]

Check again connection of the grip to the base - loosen the fastener a bit, press gently on the grip and tighten back the fastener while pressing on the grip to make proper contact. 

If still no dice you'll have to use the software for calibration/ troubleshooting.

[Sokol1]

4 hours ago, Niagara said:

off== only the blue light on .. by the way  it is a standard ver= no thumb hat switch =just a button ..

 

Is  SCG Lite version, you need move X, Y and twist axes during calibration.

[Tarapatraptar]

... and throttle. But I think it's something different as if the calibration is incomplete only the red light is flashing; that's why I asked for software - easier to identify the issue.

[SJ_Butcher]

Do you have the latest firmware? I remember when I bought the gladiator mk2 it wasn't perfectly centered, but then I upgraded the forward and it was much better and centered precisely.