Brake Axis Dead Zone

[ColoniaLibre]

Hello comrades,

I have a problem with my hardware configuration.

I want to assign a high dead zone to the left and right brake axis and I fail. The rudder with brake axis is installed and works fine. I have assigned a low dead zone of 4% to both brake axis in IL2 and it works also fine. But if I set the high dead zone in IL2 to any valid value, IL2 do not want to save my changes.

 

I open the axis configuration (key mapping -> plane controls -> right wheel brake/left wheel brake), set the high dead zone to an valid value (like 4%) and the brake curve diagram on the right gets an update. If I use the brakes now, the gauge on top of the configuration menu shows the right behavior of the brakes.

But if I leave the configuration menu by clicking accept to save the changes and reenter the configuration menu again, the high dead zone value is reset to 0% again, as if it was never changed.

I tried two different rudders. It doesn't matter which rudder I used, the high dead zone is unsetable.

It would be nice if you could tell me what I am doing wrong, or if you have the same problem.

 

Thanks and greetings