Virpil Mongoos T-50 flight stick buttons not working

[Indufuskellum]

My problem is I upgraded my VPC software to 20200325 ,since then I get no response for the buttons in the joy tester,

Tried in IL2 the X and Y are recognized but not the buttons on Mongoos-T50 cm Flightstick,on the Mongoos-T50 cm

Throttle everything works fine.

Reading through the forum I'm pretty sure I set up both controls while they were both connected,not realizing that you

are supposed to remove one (have not been told about this in two years) !

Any help would greatly be appreciated.

skellum

[No_85_Gramps]

Here's a set of youtube tutorials for the Virpil stuff, https://www.youtube.com/playlist?list=PL2kRNYjsz2IDZWueRjHKHMqHvpYJnA8wD

Really strange about "disconnect one", found out about that the hard way sometime ago.

 

 

[Indufuskellum]

Thanks,  Tried most of there video,no success yet,strange worked for two years without a hitch,until

I updated.

[No_85_Gramps]

I don't recall exactly how to do it but there is a way to set units back to the factory defaults. A user on another forum, Cyph3r, I recall, helped me get my issue sorted out. Unfortunately he is not around anymore. I know it's a long shot but have you tried Virpil's forums?

 

Here's how to reset the throttle:

Edited April 27, 2020 by No_85_Gramps

[Indufuskellum]

Yes there is a hard setting for the joystick,which you have to open the base and short two pins unlike the throttle which has

a button to reset.

I am waiting to find out from Shadowze who seems to run the video's if this is the right way to go.

Thanks for your help.☺️

[No_85_Gramps]

Good luck, hope you can get it sorted out. I got my base/stick 2 years ago, and then 6 months after I got the throttle. That's when I ran into the problem and cyph3r got me sorted out. Once I got it up an running I decided to leave the firmware updates alone, been working great ever since.