How to convert file to Bare metal

[adler_1]

hello

How do you convert a FW190 D9 file to bare metal , step by step , only serious replies by experienced skinners please 

[Mauler]

From Jason: "Not all planes support bare metal finishes. Only some of our later models."

 

And from ICDP: "Only some aircraft have the bare metal effect added to the 3D model. IIRC Spitfire Mk IX, A20, P47, P39, P40, Mc.202".

 

I tried the D9 as well - no go. You could at most achieve a painted silver type of finish, results will vary. Good luck.

[adler_1]

hello

very interesting , i am working on the D9 right now with the parts which need to be in BM  in some rare cases . In the old days the technique of burning the grey layer was used . the tool is available in PS . I will keep experimenting and i will post my results here . the lower section i am satisfied with but for some reason the cowling is not giving the same BM glitter look yet its the same layer color . 

Edited February 4, 2020 by dog1

[adler_1]

here is the result of dodge and burn on cowling only and a general clean up of the surface . 

[adler_1]

final product for today

[Skywarp]

On 2/4/2020 at 6:31 AM, Mauler said:

From Jason: "Not all planes support bare metal finishes. Only some of our later models."

 

And from ICDP: "Only some aircraft have the bare metal effect added to the 3D model. IIRC Spitfire Mk IX, A20, P47, P39, P40, Mc.202".

 

I tried the D9 as well - no go. You could at most achieve a painted silver type of finish, results will vary. Good luck.

 

Bare metal effect doesn't work in P-40. I tryed several times.

[[I./JG62]steppa]

This is the best i could do. As you can see it always depends on the angle you look at it, sufficient to shoot at but not very pretty.

[adler_1]

Steppa

did you use curves or level to get your result ? or what other method did you use ? as i mentioned above the lower wing came out fine but the cowling sticks to grey . 

Edited August 31, 2020 by adler_1