Hotas Warthog

[E69Guincho]

Hello everyone

I need help in relation to Hotas Warthog, specifically with the levers of gases.
Time ago I was flying well with him, but a few months ago I have had problems with the acceleration of the engines, I do not work the levers of gases
I'm going to Configuration, and in Motor Power I try to configure the levers of gases and I recognize them as "Yoy-b29" and "Yoy-b30", as you can see they are buttons
Well, I can not fly, as you can see
Let's see if you can please help me solve this problem
Thanks for the attention and greetings

[dburne]

You need to clear out those button assignment for the axis.

Then go in and assign the axis to the throttle. Leave the throttle about at center position, click on the axis assignment, then move the throttle fully forward then all the way back. It should then register the axis for your throttle.

 

Check the movement in the game, if reversed go in and tick the reverse box.

Edited April 10, 2018 by dburne

[Bando]

If it keeps recognizing something else, it may well be another device that "jitters". Disconnect that device from usb and try again. Once set up the "jittering" device can be plugged in again.

[fiddlinjim]

I have used the TM Warthog for years and the problem I almost always find if I have trouble it is  that their there is more 

than one assignment or key binding to the button or axis giving trouble.   Go back and make double sure that there are no double assignments

to that particular control function and  then make sure that you have it  properly assigned to the function you want.