electronic project

[BP_Lizard]

You guys are freakin’ wizards! Hat off to you guys.

[Sokol1]

When you close briefly*  the reset pins, Arduino COM turn mode only for 8 seconds.

 

Tick the option "Auto-start upload the firmware when COM is active" help in don't miss the time frame for upload the firmware.

 

When firmware is upload with success - you see a DOS window blink for some seconds, a device called "MMJ_reset" appear in "device list and configuration" of MMJoySetup, is your new "joystick controller".

 

* Some users report need do this "reset" 2 times in sequence, as if are making a mouse double click.

 

 

 

 

 

 

 

 

 

 

Edited April 18, 2018 by Sokol1

[Helo]

2 hours ago, Sokol1 said:

Pri zatvorení krátko * RESET piny, Arduino COM režim zapnúť len po dobu 8 sekúnd.

 

Zaškrtnite možnosť "Auto-start nahrať firmware, keď COM je aktívna" pomoc pri nenechajte si ujsť časový rámec pre nahranie firmware.

 

Ak je firmvér nahrať s úspechom - uvidíte okno blikať DOS na niekoľko sekúnd, zariadenie s názvom "MMJ_reset" sa objaví v "zozname zariadení a konfiguráciu" z MMJoySetup, je váš nový "joystick regulátor".

 

* Niektorí používatelia hlásia, je potrebné si tento "reset" 2 krát za sebou, ako by sa robiť myšou dvojklik.

 

 

 

 

 

 

 

 

 

 

Hello, Thank you very much ...: D That double click was needed in my case .. I could not help with that, I thought it was a malfunctioning Aurdino board ... Great thanks again ..