Control settings for 3D Extreme Pro

[ll./JG77_JadeBandit]

Hey everyone, so with the newest release of early access there have been a few threads about how wobbly/nervous the plan feels. I have seen some people post settings they use for their CH or Warthog setups but these are just to sensitive for the 3D Extreme Pro.

 

 Here is what I have been using and it has been working really well so far, reduces a lot of the snap movements and wobble when trying to make fine adjustments. These settings are for the BF109 though, I haven't tested this out with the Lagg yet.

 

 

Pitch:

sensitivity = 0.35

Dead zone Center = 0.05 (not sure if this is working atm, it always resets to 0 when I open the curve tab)

Dead zone Edges = 0

 

Roll:

sensitivity = 0.2

Dead zone center = 0.05

Dead zone edges = 0

 

Yaw:

sensitivity = 0.4

Dead zone center = 0.05

Dead zone center = 0

 

 Well I hope this helps some of you out there having issues setting up your 3d extreme's, please let me know if these settings work for you or post feedback if you have any suggestions on improvement's.

[II./JG27_Rich]

I have the same stick and it's going in the garbage in a month

[J4SCrisZeri]

I have the logitech will try it thank you very much

[germanicusgermanicus1936]

Saitek x52 pro?? Would like guidance from experienced simmer for curve profiles..many thanks..