Problem with Ju52 trim since 2.008

[JG300_Olrik]

Hello,

 

I noticed the Ju 52 trim  behaviour set on an axis has changed since 2.008.

 

Before : when moving the axis from min to neutral and from neutral to max, linear response from -100% to 0% and from 0% to +100% : easy to tune

Now (since 2.008) : a large dead zone from center to almost min or max : the response still 0% ; when you reach the last millimeters of the axis course, the response increase very quickly from 0% to 100% (or 0% to -100% opposite way) ; it's quite impossible to adjust the trim yet.

 

Some told me same issue with Bf 109 stabilizer but I didn't try since 2.008 (was ok before too).

 

I use Saitek axis, drivers are ok, and no dead zone in my axis settings.

 

Thanks for seeing.

 

Best regards

[=TBAS=Sshadow14]

This is not a bug i believe they fixed it so 109 Stab could no longer be bound to an axis with same travel rates (as people were abusing the exploit to turn harder) and now must be bound to keys like FW190 ??

 

[JG300_Olrik]

SOLVED

 

My hotas settings had been modified sinced I installed 2.008. Axis had large deadzone I didnt set before !

I reinstalled Saitek drivers and made settings again ; all is fine now.