CH script help needed

[KG200_Volker]

Trying to get some help from CH hangar but nobody answers, If anyone has knowledge of scripting for CH products I need some help.

 

The problem is the jittery pots of throttle quadrant, I tried so far the solutions that I have found here and there over Internet and they didn't solve the problem. There is just an improvement with the powered sub hub solution.

 

I ve found this script that's works very well but a new problem arises :

 

https://www.reddit.com/r/hoggit/comments/4wl1ii/remove_all_jitter_from_your_ch_products_with_this/

 

For the throtle quadrant it negates the detent zone and I can't assign any buttons now there.

 

Can anyone correct the script in order to have 0 to 100% travel past the detent zone?