Cannot Set Full Engine Power

[Albino]

Hello everyone

 

I'm having a problem with the zoom and throttle axis' on my Saitek X-52 Pro. The limits of each axis are not recognised properly in BOS. However, in the Saitek Control Panel the whole axis is read correctly.

 

BOS does not recognise when I have set the throttle to either 0% or 100%. The picture shows what BOS sees on the Z axis with the throttle position moved all the way forward. It tops out around 94% with the RPM limiter off in flight. I can work it up a few % with small back and forth movements. Likewise when moved all the way back engine power remains at around 5%. Needless to say this makes taking off, especially in heavily laden aircraft, difficult.

 

The same issue occurs on the P Axis which I use for zoom. In order to zoom all the way in or out I have to also use the mouse wheel.

 

 

Does anyone else experience this issue? Can anyone propose a solution? Eg; deleting an INI file somewhere? This has been an issue since at least 1.103. I'm running Windows 10.

 

Regards

Albino

 

[Dakpilot]

Try calibrating in Windows

 

Cheers Dakpilot

[Matt]

That's what dead zones are there for. So just use a few % of dead zones and you should be set.