CH Pedal problem

[mondog]

So I've been using some CH Pedals with Il2:BOS and all through the test phase they've worked fine (and according to the CH control manager, they still do.) but last night was reinstalled IL2:BOS and started playing again but had a strange problem:

 

I can assign my pedals fine to the rudder and to the left and right toes to brakes. The sliders work fine for the rudder and there is no problem  - they work as they should. However using the toe control doesn't seem to work at all when I go to the configuration for the dead zone/sensitivity. I can assign the toe but when I go and change the deadzone there is no response in that window. The weird thing is this did previously work OK apart from the Right toe was always inverted when first selected so I had to invert for them to no be always 100% breaking the right wheel.

 

I reinstalled the pedals, some problem persists. 

 

Has anyone else experience this? Is it the game? I doubt it's the controller as they calibrate fine in the CH control manager and the toes are assignable. Anyway, it's a bit of a problem! 

[limeymcscrote]

Yeah, there's something wrong with the way some games see the CH pedals, I have similar problems. In BoS the slightest touch activates my right toe brake, I have to conciously tilt my foot back to disengage it. It even shows visually when looking at the in-game pedals.

[mondog]

I check it out on DCS last night and they work fine on that. So it's safe to assume that it's just IL2:BOS. The strange thing is they worked absolutely fine during the entire pre-release phase.