Jump to content
Sign in to follow this  
TP_Merlin

Virpil MongoosT-50CM - Throttle and RPM move together

Recommended Posts

I cannot get the Throttle and rpm to move independent of each other for any plane. any  ideas ?

 

Share this post


Link to post
Share on other sites

Hey Merlin, 

 

Check you don't have throttle and rpm bound to the same axis (or the one to each throttle axis and then have them physically locked together). 

 

Also do you have any engine assists on? 

 

Hope this is helpful. 

Share this post


Link to post
Share on other sites

Probable some "engine aids" is enable in difficult settings, limiting your control over engine.

Share this post


Link to post
Share on other sites
On 2/18/2020 at 9:09 AM, TP_Merlin said:

I cannot get the Throttle and rpm to move independent of each other for any plane. any  ideas ?

 

Thought I remember... ruffle, ruffle, ruffle... Ah Here it is. Have you tried Settings/ Key mapping/ Engine controls. Third from the bottom, "Interconnect throttle and prop controls"? Default keystroke is LShft + I

 

HTH,

Craig

 

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...